News Center

Company News

Industry News

Media News

Product Information

FAQ

Installation of TSC 244 Barcode Printer Barcode Paper

Installation of TSC 244 Barcode Printer Barcode Paper

Welcome everyone to visit Yongli bar code website. The following small editor will teach you the installation of TSC244 bar code printer bar code paper through graphic examples: Step 1: Open the bar code machine cover, then lift the bar code machine cover next to the machine head, and then replace the bar code paper and carbon tape. Many people will not change and get stuck here. Step 2: Take out the bar code paper shaft and pull out the baffles on both sides, install the new bar code paper, pay attention to the direction, and discharge the paper upward. Step 3 as shown in the following figure: Pass the bar code paper under the head. Part 4 as shown in the following figure: Move the two clips under the head to the middle.

09

2016

/

06

How many do you know about the quality of barcode printer printing?

How many do you know about the quality of barcode printer printing?

Bar code printer after a period of time appears bar code printer print out the content is not very clear, because the impact of bar code printer print quality is still very much, such as the choice of font, printer resolution and the choice of bar code carbon tape will affect the print quality. Yongli bar code arrangement provides: 1. Select the appropriate font and different fonts will have different printing effects. Select ARIAL, bold, etc., and then bold the font. Usually, printing seems to be much better. 2, the printer resolution if the resolution is very high printer

22

2017

/

06

What if the barcode scanning gun cannot read the barcode?

What if the barcode scanning gun cannot read the barcode?

What if the barcode scanner can't read the barcode? The following yongli barcode editor introduces several reasons why the barcode scanner can't read the barcode, hoping to help you in need. 1. The function of reading this barcode is not turned on. (There are many bar code rules, and the general bar code gun can only identify several common bar codes unless specifically required) 2. Bar codes do not conform to the specifications, such as the lack of necessary blank areas, the low contrast between bar and blank, and the inappropriate width ratio between bar and blank. 3, direct sunlight, photosensitive device into the saturation zone. 4, bar code surface covered with transparent material, reflective degree is too high, although the eyes can

17

2020

/

06

Daily cleaning method of barcode printer

Daily cleaning method of barcode printer

Bar code printer daily cleaning method, in order to ensure the quality of the bar code printer and long-term good performance, it needs to be cleaned regularly, the more frequently the bar code printer is used, the more often it should be cleaned. (Infrequent use = weekly cleaning; Frequent use = daily cleaning) First of all, it is an important part of the barcode printer_barcode print head cleaning method (1) To clean the print head regularly and regularly, the cleaning tool can use cotton swabs and alcohol. Turn off the power supply of the bar code printer, keep the same direction when wiping (avoid dirt residue when wiping back and forth), turn up the print head, remove the ribbon and label paper, and clean it with the print head soaked in

18

2015

/

06

How to reduce the scratch of the print head of the bar code machine

How to reduce the scratch of the print head of the bar code machine

Factors that cause premature damage to the print head of the barcode printer: scratch-the long-term movement of the label/ribbon through the print head will wear the protective layer of the ceramic coating, exposing the print head needle (dot) and eventually damage it. The normal maintenance method of bar code printer The print head is the most fragile and vulnerable device of the bar code printer. It is a worn-out product like a car and will eventually be damaged. However, constant attention to maintenance can prolong the life of the print head. In order to play the best role, when each with a roll of ribbon or a roll of thermal paper to clean the print head. Note that when cleaning the print head, take off the ring to prevent scratching the print head, and use a grounding metal tape.

16

2017

/

06

< 1...323334...102 >