News Center

Daily cleaning method of barcode printer

Release Time:2015-06-18

Bar code printer daily cleaning method, in order to ensure the quality of the bar code printer and long-term good performance, it needs to be cleaned regularly, the more frequently the bar code printer is used, the more often it should be cleaned. (Infrequent use = weekly cleaning; Frequent use = daily cleaning)

1

The first is the important part of the barcode printer_barcode print head cleaning method

(1) to regular timing cleaning print head, cleaning tools can use cotton swabs and alcohol. Turn off the power of the bar code printer, keep the same direction when wiping (to avoid dirt residue when wiping back and forth), turn up the print head, remove the ribbon and label paper, and gently wipe the print head until it is clean with a cotton swab (or cotton cloth) soaked in the print head cleaning fluid. After that, gently dry the print head with a clean cotton swab.

(2) keep the print head clean one can get good printing effect, can also extend the life of the print head oh.

Bar code printer glue stick cleaning method

(1) Clean the bar code printer glue stick. The cleaning tool can use cotton swabs and alcohol to keep the glue stick clean, but also to get good printing results and extend the life of the print head.

(2) In the printing process, the label paper will leave a lot of small powder on the glue stick. If it is not cleaned in time, it will hurt the print head. The glue stick has been used for a long time. If there is wear or some unevenness, it will also affect the printing and damage the print head.

Cleaning Method of Barcode Printer Roller

After cleaning the print head, clean the roller with a cotton swab (or cotton cloth) soaked in 75% alcohol. The method is to scrub while rotating the roller by hand, and then dry it after cleaning. The cleaning interval between the above two steps is generally once every three days. If the barcode printer is frequently used, it is best to use it once a day.

Cleaning of transmission system of bar code printer and cleaning method in chassis

Because the general label paper is adhesive, the glue is easy to stick to the shaft and channel of the transmission, plus dust, which directly affects the printing effect, so it needs to be cleaned frequently. Generally once a week, the method is to use a cotton swab (or cotton cloth) soaked in alcohol to scrub the transmission of each shaft, the surface of the channel and the dust in the chassis, clean, dry.

Cleaning of barcode printer sensor

Keep the sensor clean so that paper errors or ribbon errors do not occur. Sensors include ribbon sensors and label sensors. See the instructions for their locations. Generally, they are cleaned once every three to six months. The method is to scrub the sensor head with a cotton swab soaked in alcohol. After cleaning, wipe it dry.

Barcode machine paper feed guide cleaning

The guide groove generally does not have a big problem, but sometimes the label is stuck in the guide groove due to man-made or label quality problems, and it is also necessary to clean it in time.

Wynn bar code warm reminder

The temperature of bar code printer is generally kept between 10-24, not too high, otherwise it is easy to reduce the service life of the print head. Pay attention to the matching of carbon tape and label. Generally, coated paper is matched with wax-based carbon tape, and synthetic paper is matched with half-tree or full-tree carbon tape. In addition, pay attention to keep the label paper flat, do not make it uneven, otherwise the print head is easy to wear.