News Center

Installation of TSC 244 Barcode Printer Barcode Paper

Release Time:2016-06-09

Welcome to visit Yongli barcode website. The following small editor will teach you the installation of TSC 244 barcode printer barcode paper through graphic examples:

Step 1: Open the cover of the barcode machine, then lift the pole beside the machine head. After a while, the barcode paper and carbon tape will have to pass through this one. Many people will not change but will be stuck here, as shown in the following figure.

1

Step 2: Take out the bar code paper shaft, unplug the baffles on both sides, install the new bar code paper, pay attention to the direction, and output the paper upward, as shown in the following figure

1

Step 3: pass the bar code paper from under the head, as shown in the following figure

1

Part 4: Push the two clips under the machine head to the middle, just pressing the paper. Note: It must be just right, not tight. If the paper is tight, it will tilt up. If it is loose, the printing will be crooked, as shown in the following figure

1

In this way, the bar code paper is basically changed. Press down the machine head and try printing some! After reading the installation of TSC 244 barcode printer barcode paper, have you learned it? Pay attention to Hongxing Yongli WeChat public platform and get the latest barcode information!

Extended reading: TSC 244 bar code printer bar code paper installation

The first step is the same as changing bar code paper. Raise the head and skip it. Look, Figure -1

Step 2: Remove the carbon ribbon shaft. Note that the new carbon ribbon should be installed on the inner shaft. The outer shaft is used to collect the waste carbon ribbon. Note: The direction of the carbon ribbon should be downward. Look, Figure -1

1

Figure -1

Step 3: Take out the carbon ribbon, pass it around from the bottom of the machine head, stick it on the front shaft, and tighten it. Look at the picture!

1

In this way, the carbon tape will be replaced. The replacement of bar code paper and carbon tape for various models of TSC bar code machine should be similar, isn't it quite simple!