News Center

Barcode printer cannot print and barcode printer paper measurement method

Release Time:2014-06-19

Barcode printer users may often encounter the situation that they cannot print and measure paper. The following small series of Hongxing Yongli [www.xingyongli.com] will tell you one by one:

barcode printer cannot printer?

As soon as the printer is turned on, the red light will be turned on, and as soon as it is printed, the light will be turned on to report an error, and normal printing cannot be carried out. The reason for this situation is that the printer cannot sense the label.

Commonly used bar code label materials are coated paper, PVC, Asian silver paper, PET and other types, of which there are 3 types of labels, gap type, continuous type, black label type, the most commonly used is gap label, gap has 3 specifications, 2mm, 3mm, 4mm.

After using the bar code printer for the first time or replacing the label with a new specification, paper measurement is required (Note: TEC bar code printers generally do not need paper measurement, as long as the label format and label type are set in the software and printed directly).

The most commonly used bar code printer paper measuring method?

1. Argox standing image printer paper measurement: turn off the power supply of the bar code machine, press and hold the "PAUS/calibration" button on the left side of the machine, and when the power supply and other paper and carbon tape start to rotate, let go of your hand, and when the machine is finished, it will be completed.

2. TECB-SX5 measuring paper: press "FEED PAUSE" to start up, enter the setting menu, and select SENSORADJ

3. IntermecPF4I paper measurement: after starting up, press shift FEED

4. TSC-243E paper measurement: press and hold the PAUSE key to start the machine, and let go when the machine starts to walk paper.

5. IntermecPD41 paper measurement: after starting up normally, press FEED key. if you can walk a piece of paper normally, the printer can measure paper normally; Otherwise, the printer needs to measure paper. The method is to turn off the printer, press and hold the FEED key to turn on the machine, and release the FEED key when the first light flashes. The printer will automatically set up the printer and measure the paper automatically (this method is not used to measure paper); it is best to print a test page and let the machine automatically measure the paper.

　　6、Zebra105sl测纸：feed pause cancel

7. IntermecPC4 paper measurement: press and hold the FEED key to start the machine-let go for about 10 seconds-the printer will walk through the paper and then print out some parameters-turn off and start the machine to complete

8. Zebra400 paper measurement: Press and hold PAUSE to start the printer. Click setup, go to the right and look at a headopen inside. CANBILECT

9. Intermec3400E paper measurement: press and hold the FEED/PAUSE key to start the machine until the printer starts printing and release the hand (the light ALEX in the middle turns off and releases the hand)

10. DatamaxI-4308 the paper measurement: Press MENU key to enter "mediasetting", then turn over the screen after entering, select "sensorcalibration" and press ENT key to confirm. The system prompts "performcalibration", press ENT key to confirm. The system prompts "removelabelstock,pressanykey". After removing the label paper, close the print head and press the tolerance key. The system prompts "scanbacking,pressanykey", peel off one piece of label paper, install the blank part under the detector ground, close the print head, and press the tolerance key. The system prompts "scan,pressanykey", put the label paper into one piece, put the label part under the detector floor, close the print head, and press the tolerance key. The system prompts "calibrationcomplete". Press the FEED key to print (2) and hold the FEED key for more than 4 seconds. Labels can likewise be detected.