Paper Jumping Processing Method of TSC TTP-244plus Barcode Printer

Release Time:2020-07-29

Paper Jumping Phenomenon Occurs During Printing of TSC TTP-244plus Bar Code Printer

Cause: This phenomenon is due to the machine failed to detect the paper or the paper is not standard.

Solution: First, look at whether the label paper is not standardized and whether the size of each label is consistent. If this is the reason, only the label paper can be replaced. If there is no problem with the label detected, then the machine fails to detect the paper and needs to re-test the paper. Turn off the machine first, then press and hold the PAUSE and FEED keys at the same time and then turn it on until the three display lights flash once at the same time to release the machine to initialize the machine, then turn it off, press and hold the PAUSE key to measure the paper, wait until the machine outputs the paper and then release the hand until the machine retracts.

The TSC TTP-244plus barcode printer makes a loud noise during printing, and the cover of the printer is difficult to cover.

Reason: The ribbon reel is installed backwards.

Solution: Check whether the lower ribbon reel is installed backwards, and then install it correctly.

Recommend

Shenzhen Hongxing Yongli Company Headquarters Relocation Notice

Thanks to your long-term strong support and cooperation, here, Hongxing Yongli all staff would like to express our heartfelt thanks! Due to the needs of our business development and the expansion of the company's scale, the company will move to a new office address from July 20. The specific contact information is attached.

Learn more