News Center

The use of bar code printer safety and precautions

Release Time:2020-07-10

The use of bar code printer safety and precautions

Bar code printer is one of the office supplies, supplies. The correct use of the barcode printer effectively prolongs its service life. The following Hongxing Yongli technology provides the use safety and precautions of the barcode printer:

　　

 

Zebra Industrial Barcode Printer

1. Bar code printer work may interfere with radio, television and other communication products, so please remove these products to avoid signal interference;

2. Please place the barcode printer on a horizontal, solid desktop or flat surface;

3. Bar code printer should be away from damp, water, high temperature places;

4. Please refer to the specification label on the back panel of the bar code printer to make sure that the power supply specification you are using is correct. Be sure to make sure that the power supply voltage switch (110V/230V) is consistent with the power supply voltage in your area, otherwise it will cause the machine to burn or cannot operate normally;

5. When the machine has been connected to the power supply, do not open the chassis;

6. Bar code printer can not be disassembled, otherwise it will lose the warranty and cause damage;

7. Before cleaning the barcode printer, please cut off the power of the barcode printer, do not use liquid or spray-like cleaner to clean the barcode printer, please gently wipe the barcode printer with a soft cloth or cotton;

8. Do not use the barcode printer at room temperature above 40 degrees Celsius, otherwise it will damage the barcode printer;

9. The heat dissipation holes around the barcode printer should be avoided from being blocked and affecting the heat dissipation;

The power cord of the barcode printer should be placed in a suitable and safe place, and the voltage and current that the power cord can carry should be greater than the voltage and current identified by the printer;

11. Do not drop any liquid into the heat dissipation hole of the printer to avoid fire or short circuit;

12. When the barcode printer is not used frequently, the connection and power cord between the barcode printer and the host should be disconnected to avoid instantaneous overload voltage damage to the barcode printer.